The output may vary slightly due to the configuration of the unit. You will then be presented with a shell prompt, which will accept commands:
When prompted for the password, type rootme (nothing will be echoed while you are typing) and press.
Terminal emulator mac serial password#
The password is set to rootme when shipped from the factory. Note : If a terminal session has just been closed, it can take up to 10 seconds for a new session to start.You should log in as root, which is the standard Unix “superuser”. The default settings for this port are as follows:
Terminal emulator mac serial serial#
The “DATA OUT” port can be connected to a serial terminal or PC running either Scream! or terminal emulation software. A combined power and serial cable is provided with both CMG-EAMs and CMG-DCMs for connection to this port. The CMG-DCM does not have a dedicated console port: the “DATA OUT” port is normally used for console access. These settings are not configurable, preventing accidental lock-out due to inadvertent changing of the port settings. The default settings for this port are as follows:Ĩ data bits, no parity, 1 stop bit (8N1) and
pins 2 (RxD), 3 (TxD) and 5 (ground) connected straight through) to a serial terminal or to a PC running either Scream! or terminal emulation software. It can be connected via a serial (RS232) modem cable (i.e. The CMG-EAM's console port is a 9-pin 'D' connector (with DCE wiring) located under its lid. The hardware fitted to CMG-NAMs varies but one serial port will usually be designated as the console port. The CMG-DCM has three serial ports: the port labelled “DATA OUT” is normally used for console access and a combined serial and power cable is provided for this purpose. The CMG-EAM has four serial ports, any of which can be configured for this purpose, although the 'D' connector located under the lid is a dedicated console port. If DHCP is not available, serial access is required in order to set up the network parameters.
The configuration interface as accessible using a web browser or, in character mode, using ssh or over a serial connection from a terminal emulator.Īll models are fitted with at least one network port which can be automatically configured using DHCP. The CMG-EAM can be configured and monitored either over an Ethernet network or via a serial (RS232) line. Previous Next 1. Introduction 2. First Steps 3. Configuration System Overview 4. Firmware Upgrades 5. Data Handling Overview 6. Configuring Networking 7. Digitiser Configuration 8. Digitiser Synchronisation 9. Receiving Data 10. Recording and Retrieving Data 11. Transmitting Data 12. Building Networks 13. Monitoring Operations 14. Appendices 15. Revision history Section Index: 2.1. Connecting to the Serial Port 2.2. Connecting to the network port 2.3. Changing the password Chapter 2.
0 kommentar(er)
